Cisco 3545 PRI Installation And Upgrade Manual page 32

How to Perform the Initial Gateway Configuration
Table 2-6
Requirements
PC with available serial port and
terminal emulator software installed
RS-232 terminal cable (shipped with
the unit)
Procedure
Connect the
Step 1
Connect the power cable.
Step 2
Start the terminal emulation application on the PC.
Step 3
Set the communication settings in the terminal emulation application on the PC as follows:
Step 4
Baud rate: 9600
•
Data bits: 8
•
Parity: None
•
• Stop bits: 1
• Flow control: None
Step 5 Turn on the power to the gateway.
After the terminal emulator session starts, press the RST button on the gateway front panel to reset the
Step 6
module.
A log of the auto-boot events and a VxWorks banner scrolls across the computer monitor.
Note
Step 7 When the message "Press any key to start configuration" appears on the screen, press any key within 6
seconds.
The network configuration Main menu displays:
Caution
At the prompt, type N to configure default network port values and press Enter.
Step 8
At the Enter IP address for default interface prompt, type the IP address you want to assign to the
Step 9
gateway and press Enter.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Releases 5.6 and 5.7
2-12
Requirements for Setting the IP Address
cable to the PC terminal.
supplied terminal
When the gateway is started for the first time, two VxWorks banners appear. The configuration
option appears after the second banner.
Press any Key To start configuration...
Main menu
Enter <N> to configure default network port values
Enter <P> to change the configuration software password
Enter <A> to display advanced configuration menu
Enter <Q> to quit configuration menu and start GW
If you do not press a key before the countdown ends, the device continues its initialization and
you can only configure the device by pressing the RST button on the front panel.
Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway
Notes
OL-17011-01