Changing Gear Oil - Yamaha F2.5A Owner's Manual

4-43
EMU01460¯

CHANGING GEAR OIL

WARNING
@
G Be sure the outboard is securely fas-
tened to the transom or a stable stand.
You could be severely injured if the
outboard falls on you.
G Never get under the lower unit while it
is tilted, even when the tilt-support
lever/knob is locked. Severe injury
could occur if the outboard acciden-
tally falls.
@
1) Tilt the outboard motor so that the oil
drain plug is at the lowest point possible.
2) Place a suitable container under the
gear-case.
3) Remove the oil drain plug 1.
4) Remove the oil level plug 2 to allow the
oil to drain completely.
CAUTION:
@
Inspect the used oil after it has been
drained. If the oil is milky, water is getting
into the gear-case which can cause gear
damage. Consult a Yamaha dealer for
repair of the lower unit seals.
@
NOTE:
@
For disposal of used oil consult your Yamaha
dealer.
@
5) With the outboard motor in a vertical
position, and using a flexible or pressur-
ized filling device, inject the gear oil into
the oil drain plug hole.
Gear oil grade/capacity:
Refer to "SPECIFICATIONS," page 4-1.
6) When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
7) Insert and tighten the oil drain plug.
GB