en operation
Fold the measuring aid down and
3.
click it into place.
Push in the detergent drawer.
4.
13.7 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→ Page 30.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press Start/Reload.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the "Ready in" time.
a After the programme has ended,
the display shows: "End".
32
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/Re-
load.
To resume the programme, after
3.
the desired soaking time, press
Start/Reload.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement: A programme has
started.
→ "Starting the programme",
Page 32
Press Start/Reload.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start/Reload.
5.
13.11 Cancelling the pro-
gramme
Press Start/Reload.
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.