Heater Hardware Disconnect - Dimplex XLF50 Installation And User Manual

Installation

Heater Hardware Disconnect

The fireplace heater can be permanently disabled by removing the electronic jumper on the main control board.
!
NOTE: Heater hardware disconnect will permanently disable the heater and fan. Follow these instructions only
when an installation without heat is required. Temporary disabling of the heater can be achieved through the
hidden touch controls. See "Heat Disable" in Operation section (page 18) for instructions.
To disconnect the heater and fan permanently:
1. Locate the main control board. The heater hardware disconnect jumper location is labeled
"HT EN". (Figure 10)
2. Pull out the heater hardware disconnect jumper.
Heater Hardware
Disconnect Jumper
14
Figure 10
HT EN
www.dimplex.com