Electrical Installation - Bosch HUI34253UC Installation Instructions Manual

INSTALLATION

Electrical Installation

CAUTION: Installation work and electrical wiring must
be done by qualifi ed person(s) in accordance with all
applicable codes and standards, including fi re-rated
construction.
CAUTION: Before installing, turn off power supply
at the service panel. Lock service panel to prevent
power from being turned on accidentally.
1. Perform the electrical connection as follow: Using UL
approved wire nuts, connect BLACK wire from house
wiring to BLACK wire from hood connector, WHITE wire
from house wiring to WHITE wire from hood connector
and GREEN or bare ground wire from house wiring to
GREEN wire from hood connector. Then, remove and set
aside the screw shown in illustration below for later use.
BLACK to
BLACK
GREEN to
GROUND
2. Reassemble the top section of the electrical cover to the
hood shell using its 2 retaining screws.
English 14
WHITE to
WHITE
Hood
Connector
Remove
this screw
Screws
3. Remove and set aside the fi lters from the module and
frame assembly by opening the latch and fold down the
metal grease fi lter. Simultaneously use your other hand to
grasp under the metal grease fi lter and remove from the frame
assembly.
4. Assemble the module and frame assembly to the hood
shell; align the keyhole slots to the 3 remaining screws
located on the module and frame support. Slide until the
screws are engaged in the small part of the keyholes (see
left insets). Put back in place the screw removed in step 1,
then tighten the 3 remaining screws in order to secure the
module and frame assembly to the hood.
Align Slide
5. Connect the hood connector to its connector (darker grey
part in illustration below).