DeWalt DCD701 Manual page 17

an indication of the charge left on the battery pack. It
does not indicate tool functionality and is subject to
variation based on product components, temperature
and end-user application.
Belt Hook (Fig. C)
Optional Accessories
WARNING: To reduce the risk of serious personal
injury, DO NOT suspend tool overhead or suspend
objects from the belt hook. ONLY hang tool's belt
hook from a work belt.
WARNING: To reduce the risk of serious
personal injury, ensure the screw holding the
belt hook is secure. iMPORTAnT: When attaching or
replacing a belt hook, use only the screw that is
provided. Be sure to securely tighten the screw. A belt
hook can be be attached to either side of the tool
11
using only the screw provided, to accommodate left-
12
or right-handed users. If the belt hook is not desired at
all, it can be removed from the tool.
To move the belt hook, remove the screw
it in place then reassemble on the opposite side. Be sure
to securely tighten the screw.
Installing a Bit or Accessory into a
Keyless Chuck (Fig. D)
WARNING: Do not attempt to tighten drill bits
(or any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to
the chuck and personal injury may result. Always
lock off trigger switch and disconnect tool from
power source when
changing acces sories.
WARNING: Always ensure the bit is secure before
starting the tool. A loose bit may eject from tool
causing possible personal injury.
Your tool features a keyless chuck
rotating sleeve 9 for one-handed operation of the
chuck. To insert a drill bit or other accessory, follow
these steps.
1. Turn tool off and remove battery pack.
2. Grasp the black sleeve of the chuck with one hand and
use the other hand to secure the tool. Rotate the
sleeve counterclockwise far enough to accept the
desired accessory.
3. Insert the accessory about 19 mm into the chuck and
tighten securely by rotating the chuck sleeve clockwise
with one hand while holding the tool with the other.
Your tool is equipped with an automatic spindle lock
mechanism. This allows you to open and close the
chuck with one hand.
Be sure to tighten chuck with one hand on the chuck
sleeve and one hand holding the tool for maximum
tightness. To release the accessory, repeat steps 1 and 2
above.
Speed Selection (Fig. A)
The tool features two speed settings for greater
versatility. nOTE: Do not change speeds when the tool
is running. Always allow the tool to come to a complete
stop before changing speed.
1. To select speed 1 (high torque setting), turn the tool
off and permit it to stop. Slide the speed selector
back (away from the chuck).
that holds
12
2. To select speed 2 (high speed setting), turn the tool
off and permit it to stop. Slide the speed selector
forward (toward the chuck).
If the tool does not change speeds, confirm that the
speed selection switch is completely engaged in the
forward or back position.
Mode Selection (Fig. A)
The mode selection collar
correct operating mode depending upon the planned
application.
To select, rotate the collar until the desired symbol
aligns with the arrow.
symbol
1-15
with one
10
can be used to select the
6
Mode
Drilling
Screwdriving (higher number =
greater torque)
Hammerdrilling (DCD706 only)
English
7
7
1
3