LG DT22VSSG Owner's Manual page 20

20
INSTALLATION INSTRUCTIONS
7. Lift out the gray interlock button in the side of the
door.
Make sure to remove the spring with the interlock
button and to keep the two together. Set the interlock
button aside. Do not confuse these with the interlock
buttons from the top of the outer door.
8. Remove the side lock rod.
Remove the side lock rod from the lower hinge
bracket by lifting the top end of the rod and sliding it
toward the top of the door. The spring should remain
attached to the lock rod. Set the lock rod aside.
9. Remove the top lock rod.
a. Slide the lock rod to the right to remove it from the
hinge assembly on the left side.
b. While sliding the lock rod right, lift the right end up
and out of the guides.
NOTE
Do not remove the two inner lock rods and two
interlock buttons located underneath the top lock rod.
They do NOT need to be reversed.
10. Remove the upper hinge pivot.
Once the top lock rod has been removed, the
hinge pivot can easily be removed from the hinge
assembly on the upper left and set aside.
Upper hinge
assembly
Upper
hinge
pivot
11. Reverse the upper hinge assembly and hinge
filler.
Lift out the upper hinge filler (on the right) and set
it aside. Carefully lift the upper hinge assembly (on
the left) out of the outer door frame, using a small
flat blade screwdriver if necessary. Rotate the hinge
Spring
assembly 180 degrees and install it on the upper
right side of the outer door. You will need to press
firmly to install the hinge assembly. The hinge pivot
removed in step 11 will be installed later.
now rotate the hinge filler 180 degrees and install it
on the upper left side of the door.
Upper hinge assembly
Upper hinge pivot
Upper hinge filler