Battery Description; Low Battery - Polaris PBS 0609L Manual Instruction

indicating that the system is working and in self-balancing mode. Put another foot on the
second pedal horizontally, maintaining the balance of the body and the horizontal position of
the first foot. Standing with both feet on the pedals, in the absence of movement, bring the body
into a relaxed condition. Slightly bend at the knees to maintain balance.
NOTE: This model is equipped with a self-balancing function that makes it easier to enter and exit the
gyroscooter pedals. This function is activated by default. To turn off self-balancing, press and hold the
on button for at least 5 seconds while the device is. You will hear three beeps, after which the self-
balancing mode will be turned off. To switch on the self-balancing, do the same procedures.
3. Controlling the state of balance, stand quietly on the gyroscooter. The device will remain
stationary. Try to bend a little forward or backward, feeling the reaction of the device.
Remember that the amplitude of your movements should not be large.
NOTE: If the balancing of the gyroscooter on the go does not occur, the system can not come in
a self-balancing state. In this case, do not use the device. Try turning the device off and on again.
If this does not work, you may need to calibrate (see Section 16, "Trouble Shooting").
4. Slightly shifting the center of gravity by bending the body forward or backward, try to move in
the direction of incline. Pressing the pedal with the toe of the left leg (carrying the weight to the
left leg) leads to turning to the right, pressing the toe of the right foot (carrying the weight to the
right leg) leads to turning to the left.
Avoid abrupt movements to incline slightly. Control the direction of the device. Use right foot to
turn left, left foot to turn right.
Practice getting off the device. Stop and catch the balance position before you get off. Remove
5.
one leg, leaving the gyroscooter in front of you. Transfer the balance to the foot that is on the
ground, remove the second leg from the footboard.
NOTE: For reasons of safety, the gyroscooter is equipped with forced speed limiting mode. Depending on the
current operating mode (user or training), the maximum speed of the gyroscooter is limited (10 and 6 km
/ h). When the maximum speed is reached, the gyroscooter will beep and automatically begin to slow
down, trying to turn the platform relative to the ground in the direction corresponding to braking.
In the "User Mode", the braking will occur at a speed of about 5 km/h, after which the scooter will return
to normal driving mode. In the "Training Mode", the braking will take place within approximately one
meter of the distance, after which the device will return to the normal driving mode.
IMPORTANT! It is forbidden (more than 5 seconds) to prevent attempts of the device to reduce the
speed, in this case increases the pressure on the motors, and the device can turn them off after the motors
overheated.
NOTE: If you lose control over the device (for example, if the user jumps off or falls off the device), the
automatic device will attempt to limit the "roll-up" of the scooter. To do this, if the scooter is turned
downside, the engines of both wheels are automatically locked, and the scooter produces an uninterrupted
sound signal. When the scooter is in the working position, the signal will turn off and the scooter will
return to normal operation.
Before using, you must fully charge the battery; it can take up to 2 hours. Before this procedure, only
short-term activation and check of the gyroscooter operation is allowed.
To ensure your own safety and the safety of others, follow the rules of battery usage to maximize
battery life and improve battery performance.
7.1

LOW BATTERY

To prevent falling from the scooter due to a low battery charge, the continuous sound signal will turn on
automatically when battery charge reaches 15%. The speed is reduced to a minimum, and the platform
assumes a position that prevents further movement of the scooter. Activation of this mode means you to
stop riding the scooter to charge the battery. Riding a scooter with a discharged battery is prohibited.
 Do not use the battery in the following case: the battery emits an unusual odor, or excessive heat or
7

BATTERY DESCRIPTION

42