HP Vectra XW Technical Reference Manual page 63

SCA05
SCA06
SCA07
SCA08
SCA09
SCA10
1 Run Setup to view your configuration and correct any obvious errors.
2 If this fails to correct the problem, ensure that your hardware (accessory
boards, disk drives, switches, and jumpers) is configured correctly (refer
to their manuals). In particular, check that the CONFG switch on the sys-
tem board is set to Off. Make a written note of the configuration before
closing the cover.
3 If hardware settings were changed, run Setup to update the configuration
information.
1 If possible, test the keyboard and mouse by connecting them to a working
Vectra 286, 386, or 486 computer:
2 If the working computer fails, the keyboard or mouse is defective.
3 If the error remains on this computer, or if you cannot test the keyboard
and mouse, you may need to contact your service representative to deter-
mine if your system board needs replacement.
1 Ensure the keyboard is firmly connected to the correct connector on the
rear of the computer.
2 If the problem persists, your keyboard may need to be replaced. Contact
your service representative.
1 Ensure the mouse is firmly connected to the correct connector on the rear
of the computer.
2 If the problem persists, your mouse may need to be replaced. Contact
your service representative.
• Your system board may need to be replaced. Contact your service
representative.
• As a temporary solution, if you do not need the defective port, run Setup
to disable it.
• Either re-configure your accessory board or run Setup to re-configure
your built-in port.
5 Power-On Self-Test and Error Messages
Suggestions for Corrective Action
55