HP Vectra VEi8 Supplementary Manual page 20

NOTE
NOTE
Replacing the Celeron Processor (VEi7 models)
4 Position the new processor over the socket, with its corner marker
facing the corner marker on the socket.
Design 1
5 Install the new processor and lower the lever to lock it in place.
6 Apply more heat interface if required. Replace the heatsink and
fasten the clip. The retention clip will be of one of the designs shown
above.
The heat interface that bonds the heatsink to the processor can be
damaged when you change processors. You can order more heat
interface by consulting the Service Handbook, downloadable from the
"Manuals" section of
7 Replace the cover (described in this chapter).
If you replace your processor or system board, you may need to update
your BIOS. The latest BIOS for your PC and instructions on updating the
BIOS are available from:
Design 2
www.hp.com/go/vectrasupport
www.hp.com/go/vectrasupport
.
.