Advertisement
Quick Links
Advertisement
Related Manuals for Narwal T10
Summary of Contents for Narwal T10
- Page 1 YC-BC-S00023-00-01...
- Page 2 Thank you for buying Narwal product. To fully access our services, please read this manual and related diagrams carefully before using this appliance. Please keep this manual properly. This product is continually being updated, so there may be some differences between your actual product and the specifications...
-
Page 4: Servicing Of Double-Insulated Appliances
When using an electrical robot, basic precautions should always be followed, including the following : READ ALL INSTRUCTIONS BEFORE USING (THIS APPLIANCE) To reduce the risk of fire, electric shock, or injury: WARNING – 1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. - Page 5 0 C/32 F 35 C/95 F -20 C/-4 F 70 C/158 F 5 C/41 F 30 C/86 F 130 C/266 F • Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. • Use extra care when cleaning on stairs. •...
- Page 7 CAN ICES-003 (B)/NMB-003(B) The laser distance sensor of this product meets the standards for Class I Laser Products in IEC 60825-1: 2014 and will not generate hazardous laser radiation This device contains licence-exempt transmitter(s)/receiver that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
- Page 15 Please turn off the robot and remove the battery before you abandon the product. Do not discard or place battery scraps casually but hand them to professional recycling agencies for disposal.
- Page 17 19.7'' 59.1'' 0.5m / 19.7'' 0.5m / 19.7'' 1.5m / 59.1''...
- Page 20 Add Narwal detergent sheet into the Install the clean water tank and waste- clean water tank for improved mopping water tank properly in the base station results. Please be reminded not to add after verifying that there is no wastewater detergents of other brands, otherwise in the wastewater tank.
- Page 21 During the mopping process , the robot will automatically return to the base station to get the mop cleaned.
- Page 22 After completing a mopping task , the robot will return to the base station to get the mop cleaned and air dried automatically.
- Page 23 Clean it after every mopping operation...
- Page 24 It is recommended to clean it after each vacuuming operation...
- Page 25 Install the side brush with an L mark on the left side of the vacuuming module, and the one with an R mark on the right side of the vacuuming module. (You must pay attention to the left and right directions of the sidebrush during installa- tion.
- Page 28 Failed to exit the base station, please clear the way near the base station...
- Page 32 A: Mop moisture level is dependent on for how long and at what rotation speed the mop is dried after being cleaned.To ensure that mop is always effectively cleaned,the same amount of water is used to clean the mop.
- Page 33 Base station 15.79'' x 14.09'' x 17.2'' 12.36'' x 13.58'' x 4.21'' 3.8kg / 8.3 lb 7.3kg / 16.1 lb Warning:...