Maintenance And Cleaning; General Maintenance - Sunrise Medical Quickie Q700-UP M Owner's Manual

®
Quickie Q700-UP M Seating Manual
The wheelchair's lifespan is dependent on it being well maintained.
For information concerning specifi c settings, maintenance, or repair work, please
contact your Sunrise Medical authorized dealer. Always ensure you mention the
model and year of manufacture and identifi cation number provided on the serial
number label of the wheelchair when contacting your Sunrise Medical authorized
dealer.
CAUTION!
The wheelchair should be serviced by your Sunrise Medical authorized dealer once
a year or, in the case of intensive use, every six months. For a list of approved
authorized dealers in your area please contact Sunrise Medical Customer Service.
The contact details of your local Sunrise Medical Service Center can be found on
the inside front cover of this booklet.
Website addresses are on the back cover.

8.1 General maintenance

WARNING!
1. All fasteners should be checked quarterly for wear, such as loose bolts or
broken components.
2. Loose fasteners should be re-tightened according to the assembly
instructions. See section 8 for specifi ed torque values.
Note: it will be necessary to use a torque wrench.
3. Check all straps monthly for fraying, ripped seams, or other indications of
excessive wear damage. Discontinue use if damage is found.
4. Chest straps should be replaced at the fi rst indication of damage and/or
excessive wear.
5. If a broken or loose component is found, discontinue use immediately and
contact your Sunrise Medical authorized dealer for replacement.
6. Check all Velcro © fastening straps for correct adhesion when pressed
together.
7. Ensure that any contamination, such as fl uff , hair, etc is removed from the
Velcro © straps. Such contamination may aff ect adhesion.
WARNING!
1. If you are in any doubt about the performance requirements of your
wheelchair contact your Sunrise Medical authorized dealer.
2. After performing any maintenance or repairs on the wheelchair you must
ensure that it is functioning correctly before it is used.
3. All fasteners must be replaced like for like using the correct length, tensile
strength, and materials.
4. When replacing self-locking nuts, or nuts/studs secured with a thread locking
solution, ensure that a suitable thread locking solution is reapplied to the
fastener.
Daily checks
Perform the daily check routine before driving as described below.
Checking seating
1. Ensure that all the cushions are in place.
2. Ensure that the backrest is correctly fi tted and adjusted.
Checking connectors and cables
1. Ensure that all connectors are securely mated.
2. Check the condition of all cables and connectors for damage.
Checking clothing for potential entrapment
When operating the wheelchair, ensure that your clothing does not hamper the
wheelchair (i.e. too long). Before use, always ensure your clothing or accessories
do not come into contact with the wheels and/or other moving and/or rotating
parts in which they could become entangled.
General daily checks
1. Visually inspect the wheelchair to ensure the leg rests, armrests etc. are
correctly positioned and attached to the wheelchair and all fasteners are
suffi ciently tightened.
2. Ensure that the seat interface knobs are tight and secure.
247556 Rev. B

8.0 MAINTENANCE AND CLEANING

3. Check to ensure components are not leaking, and components are free from
waste/dirt. If one of these items are found, stop using the chair immediately
and contact a Sunrise Medical authorized dealer.
4. Check to ensure the caster lock is not blocked with waste/dirt.
Weekly checks
Perform the weekly check routine before driving as described below.
Checking connectors and cables
1. Ensure that all connectors are securely mated.
2. Check the condition of all cables and connectors for damage.
Checking controller
1. Check the thin rubber gaiter or boot around the base of the joystick shaft
for damage or splitting. Check visually only, do not handle the gaiter.
2. Ensure that all components of the control system are securely mounted. Do
not over-tighten any securing screws.
Checking controls
1. Switch on the hand control – Do the lights fl ash? This signifi es that there is a
fault in the electronic system.
2. Operate all of the electric options, including lights and indicators (if fi tted) to
ensure that they work correctly.
3. Drive the wheelchair in each of the drive profi les to ensure the wheelchair
performs as it did before.
General weekly checks
1. Check tires for proper infl ation level (if applicable).
2. Check frame and base for foreign objects and/or obstructions.
3. Ensure the knobs that attach the seat frame to the front of the base are not
loose.
Quarterly checks
Perform the quarterly check routine before driving as described below.
1. Check all straps for fraying, ripped seams, or other indications of excessive
wear damage. Discontinue use if damage is found and contact a Sunrise
Medical authorized dealer.
2. Check chair for any missing or loose nuts, bolts, and/or fasteners. Contact a
Sunrise Medical authorized dealer if found.
3. Check wheelchair for any broken components, unusual wear, or other
indicators of excessive wear. Discontinue use if damage is found and contact
a Sunrise Medical authorized dealer.
1. If you are in any doubt about the performance requirements of your
wheelchair contact your Sunrise Medical authorized dealer.
2. After performing any maintenance or repairs on the wheelchair you must
ensure that it is functioning correctly before it is used.
3. A complete inspection, safety check, and service should be made by a
Sunrise Medical authorized dealer at least once per year.
4. All fasteners must be replaced like for like using the correct length, tensile
strength, and materials.
5. When replacing self-locking nuts, or nuts/studs secured with a thread locking
solution, ensure that a suitable thread locking solution is reapplied to the
fastener.
6. Check all Velcro © fastening straps for correct adhesion when pressed
together.
7. Ensure that any contamination, such as fl uff , hair, etc. is removed from the
©
Velcro straps. Such contamination may aff ect adhesion.
8. Do not reuse fasteners.
24
WARNING!