Table of Contents
Advertisement
PRACTICAL ADVICE ON HOW TO USE THE REFRIGERATOR/REPLACEMENT PARTS
The "Check" display
● This fl ashing shows that there is a problem with the Automatic Ice Maker, the temperature control device or
fl ashes on the
● Consult your dealer if the fl ashing does not stop even after checking the point listed in the following table.
Control Panel for
operation
Flashing
※ 1 Pushing the button long (more than 10 seconds), the refrigerator may go into the operation check mode.
The electric supply failed
● Reduce the number of times of opening and closing the door and avoid storing food additionally until the electric supply is restored.
The refrigerator is not expected
● Unplug the power plug and maintain the inner of the refrigerator and the Automatic Ice Maker, and leave all
to use for a long term
● Any operation to remove frost is not required because this refrigerator remove frost automatically.
Remove frost
You can adjust "MIN"/"MID"/"MAX" more fi nely when setting the temperature
in the Refrigerator Compartment and the Freezer Compartment.
1. Open the Lower Freezer Door.
When you want
2. Push the Quick Cooling button on the control panel on the refrigerator door
to adjust the
3. Push the Cooling button or the Freezing button to adjust the temperature.
temperature
more fi nely
4. If you want to stop the fi ne adjustment, perform the operation of 1 and 2.
REPLACEMENT PARTS
When replacing the following parts, make sure to tell your dealer the type name and buy the special parts.
Replacing the water fi lter
● Replace the water fi lter when it becomes old.
(Replace it normally once 3 〜 4 years.)
● Ordering the replacement water fi lter
Tell your dealer the parts number: RJK-30 to buy the
replacement water fi lter. (Ice making capacity is the
same with a water fi lter removed.)
the frost removal device etc.
Flashing pattern
"Check" fl ashing
Food etc. may come in contact with the ice
3 times
tray or the stored ice amount detection lever.
"Check" fl ashing
This fl ashing shows that there is a problem.
(excluding fl ashing 3 times)
"Vacuum Compartment
The vacuum function may not work properly.
Subzero"
or
"Vacuum
It may be in the operation check mode for
Compartment Chiller"
fl ashing
serviceman. ( ※ 1)
"Large"
"Normal"
It is in process of Ice Maker Cleaning.
"Stop"
Flashing
It will fl ash if you stop ice making during the
"Stop" fl ashing
ice making process.
Door remains open for more than 1 minute. (ex:
All displays fl ashing
door is not completely closed.)
the door open to dry the refrigerator for 2 〜 3 days.
Thawed water is collected in the evaporating tray and automatically evaporates.
for more than 5 seconds until single long beep sounds.
The temperature becomes lower by 1 step every time you push the button.(If
you push the button when "MAX" is selected, the setting returns to "MIN".）
Two beeps sound and You can set the temperature by normal step.
Possible Cause
Pg.49〜51
Replacement of the vacuum packing
● Replace it if it is damaged.
● Order information about replacement parts
Type: R-S51AMJ
Check Point
Empty the Ice Compartment and perform
"Cleaning the Ice Making".
Consult your dealer.
Check the points described in "There is something
strange with the Vacuum Compartment" on P.55.
It will return to the normal mode after about 10
minutes. There is no problem with using.
Check the points described in "How to
maintain the Automatic Ice Maker" on P.51.
Check the points described in "Ice Tray" on
P.51.
Check the points described in "Door Alarm"
on P.58.
MIN MID-
MID MID-
MIN
Temperature setting
Parts number
R-S50AM 321
（低溫） （低溫）
MAX
MAX
57
Advertisement
Table of Contents
