Center Shift Adjustment; Label Attachment - Sharp SF-2220 Service Manual

9. Center shift adjustment

There is basically no need to perform the center shift adjustment
because it is made when shipping. If the center should be shifted,
adjust in the following procedures.
Make a copy. If the center is shifted as shown in Fig. 1 or Fig. 2,
loosen the four screws which are fixing the cassette grip cabinet.
Section b
Direction A
Section a
Direction B
(Note) When fixing the cassette cabinet, the fixing screws and the
cabinet clearance a and b are in symmetry.
[Reference figure]
Section b
Section a
(1) Fig. 1
Move the cassette grip cabinet in direction A, tighten two fixing
screws (a) and tow fixing screws (b) in this sequence. Make a copy
again and check the center.
[Fig.1]
Image center line (First image)
(2) Fig. 2
Move the cassette grip cabinet in direction B, tighten two fixing
screws (a) and tow fixing screws (b) in this sequence. Make a copy
again and check the center.
[Fig.2]
Image center line (First image)
Section b
Section a
Paper center line
Paper center line
4 – 7
MC-Service

10. Label attachment

A. Label attachment
Attach the magnification ratio select label packed together with the
Operation manual to the position shown in the figure below.
•
When attaching the label to the copier with the original cover.
•
When attaching the label to the optional automatic original feeder
(SF-A15)
Magnification ratio select lable
Magnification ratio select lable