Table of Contents
Advertisement
To change the temperature setting:
Electrical Shock Hazard
● Before removing any access panels or
servicing the water heater, make sure
the the electrical supply to the water
heater is turned OFF.
● Failure to follow these instructions can
result in personal injury or death.
1.
DANGER: Turn off the heater electrical supply. Do not attempt
to adjust thermostat with power on.
2.
Open the junction box door (for upper thermostat of dual element
water heater only) and/or remove the (lower) thermostat access
panel. Do not remove the plastic personnel protectors covering
the thermostats. The thermostat is factory pre-set at 140°F (60°C).
3.
Using a flat tip screwdriver, rotate the adjusting knob to the desired
temperature setting.
4.
Replace the covers and access panels, and turn on heater
electrical supply.
If you choose a higher temperature
setting, install thermostatic mixing
valves at each point-of-use to help
avoid scalding.
Burn Hazard
17
Advertisement
Table of Contents
