Scsi/Pci Lan Combo Board Features; 10Bt/100Tx Lan Controller - HP P Class 450/500/550/600/650/700/750 Reference Manual

SCSI/PCI LAN Combo Board Features

Table 3-2. SCSI/PCI LAN Combo Board Features
Interface
PCI Interface
SCSI Interface

10BT/100TX LAN Controller

The embedded 10BT/100TX LAN controller supports the following standards: 100 Mbits
per second over 2-pair, category-5, unshielded twisted pair (UTP), or shielded twisted pair
(STP); 10 BaseT, 10 Mbits per second, ISO 8802-3 (IEEE 802.3 standard).
On the rear panel there is one RJ-45 connector. There is a LED which indicates the LAN
connection status as follows:
• Off - when there is no Autonegotiation response (for example, when the LAN cable is
not connected to the network HUB.
• Blinking - during Autonegotiation
• Green (ON) - the connection has passed the Autonegotiation and a link has been
established between the LAN adapter and the network HUB/Switch.
The LAN adapter contains a connector to which an internal LAN cable may be connected
to the external start connector on the system board, necessary for the use of the Remote
Power On feature, described in detail in the User's Guide provided with the PC
Workstation. The LAN adapter that uses the Remote Power On feature must be installed
nearer the processors than any other supplementary LAN adapter card.
NOTE
Refer to the User's Guide for details concerning system configuration changes
necessary after installing a LAN adapter.
Chapter 3
Features
Full 32-bit DMA bus master.
Zero wait-state bus master data bursts.
Universal PCI bus voltage support.
16-bit single ended.
Automatically enabled active termination
Fast and Ultra SCSI data transfer capability.
SCSI TERMPWR source with auto-resetting circuit breaker
SCAM (SCSI Configured AutoMatically).
Serial NVRAM (Non-Volatile RAM) for configuration utility and SCAM.
Flash BIOS.
Fast and Ultra SCSI controlled by external SCSI cable detection.
Ultra speed requires 1.5m maximum SCSI bus.
Interface Devices and Mass-Storage
SCSI/LAN Combo Board
Drives
71