Installing Accessory Boards - HP Kayak XU04 Installation Manual

CAUTION
NOTE
HP Kayak XU PC Workstation — Installing Accessories In Your HP PC Workstation

Installing Accessory Boards

Installing Accessory Boards
Static electricity can damage electronic components. Turn OFF all
equipment. Don't let your clothes touch the accessory. To equalize the
static electricity, rest the accessory bag on top of the computer while
you are removing the accessory from the bag. Handle the accessory as
little as possible and with care.
The PC Workstation has the following accessory board slots:
Slot ISA1/PCI 5 for either a 16-bit ISA board or a full-length 32-bit
•
PCI board
Slot PCI 4 for a full-length 32-bit PCI board (with LAN\SCSI
•
combined interface board installed)
Slot PCI 3 can be used for a full-length 32-bit PCI board, and on
•
selected models, a RAIDport
adapter installed
Slot PCI 2 for a full-length 32-bit PCI board
•
Slot PCI 1 for a full-length 32-bit PCI board
•
Slot AGP for the video adapter board
•
Installing the Board
1 Disconnect the computer's power cord and any LAN connection or
telecommunications cable.
PCI boards are configured automatically when installed in the
PC Workstation.
2 Remove the computer's cover (refer to page 3) and carefully place
the PC Workstation on its side.
3 Find an empty slot. Identify the location of the slot type you want to
use (ISA or PCI).
Some boards may have preferred locations and special installation
instructions detailed in their manuals.
18 English
connector with HP FastRAID
™