HP d325 ST Hardware Reference Manual page 45

5. Insert the rear screws of the hard drive
toward the back of the drive cage until the front screws are aligned with the front
J-slots. Then lower the front of the drive. Continue to slide the drive all the way
back until it locks into place.
If replacing a diskette drive, the guide screws (front and rear) will line up on the J-
slots. Insert the guide screws into the J-slots, then slide the drive toward the back of
the drive cage until it locks into place.
Installing a Hard Drive into the 3.5-inch Drive Bay (connectors may vary)
Hardware Reference Guide
1
into the rear J-slots. Slide the drive
Hardware Upgrades
2
2-33