DDR-SDRAM DIMMs
For proper system operation, the DIMMs must be industry-standard 184-pin 2.5 volt
DDR-SDRAM DIMMs with appropriate MHz-compliant CAS Latency:
unbuffered PC 2100 266-MHz compliant CAS Latency 2 or 2.5 (CL =2 or CL =2.5)
or
unbuffered PC 2700 333-MHz compliant CAS Latency 2.5 (CL = 2.5)
The DDR-SDRAM DIMMs must also contain the mandatory Joint Electronic Device
Engineering Council (JEDEC) Serial Presence Detect (SPD) information. DIMMs
constructed with x4 SDRAM are not supported; the system may not start using
unsupported DIMMs.
The computer memory will run at its rated frequency, unless that is faster than the
processor frequency. If the module frequency is faster, then the computer will run at
the processor frequency.
Processor Front-Side-
Bus (FSB) Frequency
200 MHz
200 MHz
266 MHz
266 MHz
333 MHz
333 MHz
The PC1600 (200 MHz) and PC3200 (400 MHz) may work, but are not supported.
The system may not start using unsupported DIMMs.
Hardware Reference Guide
Memory
Module Type
PC2100 (266 MHz)
PC2700 (333 MHz)
PC2100 (266 MHz)
PC2700 (333 MHz)
PC2100 (266 MHz)
PC2700 (333 MHz)
Hardware Upgrades
Actual Memory
Frequency
200
200
266
266
266
333
2-11