Ariens Promaster 252 Owner's/Operator's Manual page 32

3
2
1
1. Limiter Bolt
2. Jam Nut
3. Steering Lever
4. Stop Bracket
Figure 21
2
1
4
OF3577
GB - 32
STEERING LEVER HANDLE
HEIGHT ADJUSTMENT
The handles have three height positions
(figure 22).
1
3
1. Eccentric Spacer
2. Handle
3. Steering Lever
1. Remove spacer, handle, and eccentric
spacer from steering lever.
NOTE: Position the right and left handles at
the same height.
2. Install spacer, handle, and eccentric
spacer in the appropriate height position.
Do not tighten nut holding eccentric
spacer.
3. Turn eccentric spacer until the right and
left handles are the same height. Tighten
nut.
PARKING BRAKE ADJUSTMENT
The parking brake might need adjustment
over time and after new brake pads have
been installed.
NOTE: After installing new brake pads in
calipers, they must be burnished by driving
for a short distance (about 30 meters) with
the brake on. To do this, bring parking brake
lever part-way up while driving normally (in a
straight line).
Check Adjustment
NOTE: Be sure to check parking brake on
both sides of unit (figure 23).
NOTE: The clearance between jam nuts and
trunnion should be 3.2 cm.
2
Position # 1
Position # 2
Position # 3
Figure 22
OF3570