ASROCK Creator WRX80 Manual page 40

Non Maskable Interrupt
Button Header
(NMI_BTN)
(see p.1, No. 35)
RGB LED Header
(4-pin RGB_LED1)
(see p.1, No. 8)
Addressable LED Headers
(3-pin ADDR_LED1)
(see p.1, No. 34)
(3-pin ADDR_LED2)
(see p.1, No. 9)
U.2 Connector
Right Angle:
(36-pin U2_1)
(see p.1, No. 26)
36
GND
1
CONTROL
1
+12V G R B
1
GND
DO_ADDR
VOUT
Please connect a NMI device to
this header.
This RGB header is used to
connect RGB LED extension
cable which allow users to choose
from various LED lighting
effects.
Caution: Never install the
RGB LED cable in the wrong
orientation; otherwise, the cable
may be damaged.
*Please refer to page 52 for
further instructions on this
header.
These two Addressable LED
headers are used to connect
Addressable LED extension cable
which allows users to choose
from various LED lighting
effects.
Caution: Never install the
Addressable LED cable in the
wrong orientation; otherwise,
the cable may be damaged.
*Please refer to page 53 for
further instructions on this
header.
This connector supports U.2
NVM Express storage devices up
to Gen4 x4 (64 Gb/s).