Set Ip Address Manually; Finish "Setup Guide - Canon Color imageCLASS MF8450c Starter Manual

Set IP Address Manually
This is the setting for the static IP address. If you need to enter the IP address manually or if the machine
obtain the IP address automatically but need to configure the setting manually, follow the procedure
below. Configure the setting for the IP address manually in the User Mode after finishing the "Setup Guide. "
In this setting, enter the IP address, subnet mask, and gateway address manually.
Press (Main Menu) → <Additional Func.> → <System Management Set.> → <Network Settings> →
<Done> → <TCP/IP Settings> → <IPv4 Settings> → <IP Address Settings> → <Manual Settings> → Enter the
IP address → Enter the subnet mask → Enter the gateway address →
Main Menu screen. → Turn OFF the main power → Restart the machine.
For more information on this setting, see "Network Settings, " in the e-Manual.

Finish "Setup Guide"

All the settings with the "Setup Guide" are complete. Follow the procedure below to finish the "Setup Guide. "
After finishing the "Setup Guide, " you need to set up the computer and software for the machine.
1
Make sure the following screen is displayed on
the display, then press [OK] to proceed to the
"Setup Guide. "
Make sure the USB cable is not connected to the machine. If
it is connected already, disconnect it from the machine.
(Main Menu) to return to the
2
Press [OK] to finish the "Setup Guide. "
2 Set Up the Machine
35