ECS 651C-M Manual page 31

Hard Disk Boot Priority (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
1. Pri.Master:
2. Pri.Slave:
3. Sec. Master:
4. Sec. Slave:
5. USBHDD0:
6. USBHDD1:
7. USBHDD2:
8. Bootable Add-in Cards
: Move
CPU L1&L2 Cache (Enabled)
All processors that can be installed in this mainboard use internal level 1 (L1) and external
level 2 (L2) cache memory to improve performance. Leave this item at the default value
for better performance.
CPU L3 Cache (Enabled)
This item is only available when processors support L3. Some high-end processors support
L3. If the CPU do support L3, you may set this item to enable or disable. Leave this item
at the default value for better performance.
Hyper-Threading Technology (Enabled)
This item is only available when the chipset supports Hyper-Threading and you are
using a Hyper-Threading CPU.
CPU L2 Cache ECC Checking (Enalbed)
The item enables or disables ECC (Error Correction Code) error checking on the CPU cache
memory. We recommend that you leave this item at the default value.
Quick Power On Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
First/Second/Third Boot Device (Floppy/Hard Disk/CDROM)
Use these three items to select the priority and order of the devices that your system
searches for an operating system at start-up time.
Boot Other Device (Enabled)
When enabled, the system searches all other possible locations for an operating system if
it fails to find one in the devices specified under the First, Second, and Third boot devices.
Swap Floppy Drive [Disabled]
If you have two floppy diskette drives in your system, this item allows you to swap the
assigned drive letters so that drive A becomes drive B, and drive B becomes drive A.
Phoenix-AwardBIOS CMOS Setup Utility
Hard Disk Boot Priority
Menu Level
Use <
to select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
PU/PD+/-/:Change Priority F10:Save ESC:Exit
Using BIOS
Item Help
> or < >
27