Easy Start; Toothbrush Handle - Philips sonicare HX3641 Manual

EasyStart
Cleaning
This Philips Sonicare model comes with the EasyStart
feature activated. The EasyStart feature gently increases
the power over the first 14 brushings to help you get
used to the brushing with the Philips Sonicare.
Activating or Deactivating EasyStart
1 Place the handle on the plugged-in charger.
2 Press and hold the power on/off button while the
handle remains on the charger.
3 Keep the power on/off button pressed until you hear
a single short beep (after 3 seconds).
4 Release the power on/off button.
5 After you release the power on/off button, you'll hear
three tones.
- Triple tone of low-med-high means the EasyStart
feature has been activated.
- Triple tone of high-med-low means the EasyStart
feature has been deactivated.
You should clean your Philips Sonicare toothbrush
regularly to remove toothpaste and other residue. Failure
to clean your Philips Sonicare toothbrush may result in an
unhygienic product and damage to it may occur.
Warning: Do not clean product or accessories with
sharp objects or in dishwasher, microwave, with
chemicals or in boiling hot water

Toothbrush handle

1 Remove the brush head and rinse the metal shaft area
with warm water. Make sure you remove any residual
toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove excess
water.
13
English