Renault MEGANE E-TECH 100% ELECTRIC 2022 User Manual page 200

ADVANCED SAFETY
4
Active emergency braking
(continued)
Settings
From the "Vehicle" World on your mul-
timedia screen 4, press the "Driving as-
sistance" menu, then the "Advanced
safety" menu to access the following
settings:
"Warning anticipation": adjust the alert
sensitivity level. To do this select:
– "Late";
– "Standard";
– "Early".
2.58
(7/17)
Temporarily not available
If the system detects a temporary fault

the warning light illuminates, or
depending on the vehicle, the
warning light illuminates in yellow on
the instrument panel.
The possible causes are:
– the system is temporarily blinded
(glare from the sun, dipped beam
headlights, bad weather conditions
etc.). The system will be operational
again when visibility conditions are
better;
– the system is temporarily interrupted
(e.g. the windscreen, front or rear
bumper or logo is obscured by dirt,
mud, snow, condensation, etc.). In
this case, park the vehicle and switch
off the engine. Clean the windscreen
and front bumper. The next time
the engine is started, after five or
ten minutes of driving, the warning
light and the message disappear.
If this is not the case, this may arise from
another cause; contact an Approved
Dealer.

Operating faults
When the function detects an operat-
ing fault, the warning lights

or, depending on the vehicle,

©
and
the instrument panel accompanied by
the message "Check Front camera" or
"Front radar to check" or "Check Driving
assist ".
Consult an approved dealer.
©
and
, appear in yellow on