Table of Contents
Advertisement
Operation
Cleanup
Flush gun and clean paint off the outside after
each work shift. Store in a dry location. Refer
to
your
sprayer
instructions. Do not leave the gun or any parts
in water or cleaning solvents.
NOTICE
To prevent damage to the gun parts, do not
leave the gun or any parts, except the tip, in
water or cleaning solvents. The gun is NOT
compatible with cleaning solvents that
contain methylene chloride.
8
manual
for
flushing
Maintenance
To avoid injury always read all warnings in
this manual and the sprayer manual,
before performing any maintenance on
the gun.
Clean/Replace Filter (6)
1.
Perform Pressure Relief Procedure,
page 5, and engage trigger lock.
2.
Disconnect fluid hose from gun at
swivel (5).
3.
Disconnect trigger guard (4) from guard
retainer (22).
4.
Unscrew handle (23) from gun (1).
5.
Remove filter (6) through top of handle
(23).
6.
Clean filter (6). Use a soft brush to
loosen and remove excess debris.
7.
Insert clean filter (6) into handle (23).
8.
Reattach handle (23) to gun (1).
Tighten securely.
9.
Reconnect trigger guard (4) to guard
retainer (22).
3A4498C
Advertisement
Table of Contents
