Operation; Spray; Clear Tip Clog - Graco FTXpress Operation, Parts, Repair

Operation

Spray

1. Disengage trigger lock.
2. Be sure the arrow shaped tip faces for-
ward (spray).
3. Hold gun perpendicular and approxi-
mately 12-inches (30 cm) from surface.
Move gun first, then pull gun trigger to
spray a test pattern.
4. Slowly increase pump pressure until
coverage is uniform and even (see
sprayer instruction manual for addi-
tional information).
Align Spray
1. Perform Pressure Relief Procedure,
page 5.
2. Loosen tip guard retaining nut.
3. Align tip guard horizontally to spray a
horizontal pattern.
4. Align tip guard vertically to spray a ver-
tical pattern.
5. Tighten tip guard retaining nut.
HORIZONTAL
3A4498C
VERTICAL

Clear Tip Clog

In the event that particles or debris clog the
spray tip, this gun is designed with a
reversible spray tip that quickly and easily
clears the particles without disassembling the
sprayer.
1. Engage trigger lock. Rotate spray tip to
unclog position. Disengage trigger lock.
Trigger gun at waste area to clear clog.
UNCLOG
ti27726a
NOTE: If spray tip is difficult to rotate when
turning to the unclog position, perform
Pressure Relief Procedure, page 5, then
turn Prime/Spray valve to spray position and
repeat step 1.
2. Engage trigger lock. Rotate spray tip
back to spray position. Disengage trig-
ger lock and continue spraying.
ti27727a
Operation
SPRAY
7