Technics SL-EH760 Service Manual page 33

6.2. Servo Adjustment Procedure
1. Turn on the power.
2. Load the test disc (SZZP1054C).
3. Hold down the REPEAT button for at least 2 seconds, and then
press the PAUSE button for at least 2 seconds while continuing to
hold down the REPEAT button.
4. Press the PLAY button, and play for 10 seconds.
5. Servo adjustment results are displayed. Refer to
further information about servo adjustment results, refer to
3.
6. Remove the disc and turn off the power.
6.3. Error code based on troubleshooting
- This unit is satisfactory if the error code is E00 and E02.
- Before testing, check that the test disc is free of scratches and
optical pickup is clean.
Fig. 6-2.
Fig. 6-3.
33
Fig. 6-2. For
Fig. 6-