Toshiba RAV-SM302KRTP-UL Installation Manual page 32

Energy saving operation
Set for the power saving operation of the air conditioner.
Energy saving operation
1.Energy saving operation
2.Energy saving ratio
3.Energy saving schedule
Return Fix
Energy saving ratio
Carry out the setting operation while the indoor unit is stopped. (Turn off the air conditioning unit before
starting the setting operation.)
Energy saving operation
1.Energy saving operation
2.Energy saving ratio
3.Energy saving schedule
Return Fix
Energy saving ratio
Energy saving ratio
75%
Return Fix
+
%
NOTE
• Cooling / heating performance may be reduced a little because its power is saved during the Energy
saving operation.
• " " appears on the display when the Energy saving operation is activated.
• The Energy saving operation cannot be set on the Follower remote control when the dual remote
control system is used.
• Adjust the clock before setting the Energy saving schedule operation. (page 31)
• The remote control may not be used for setting the Energy saving operation depending on the
settings of the central control remote control or the outdoor unit.
• The Energy saving schedule operation is not available when the clock display is blinking (the clock
has not been adjusted).
31-EN
ON / OFF
ON / OFF
Set
–
%
1
Push the [ ] / [
3
"1. Energy saving operation" on the
"Energy saving" screen.
2
To start the Energy saving operation:
After setting "2. Energy saving ratio" and
"3. Energy saving schedule", push the
" ← " [
then push the [
To stop the Energy saving operation:
Push the "
"OFF", then push the [
1
Push the [ ] / [
3
"2. Energy saving ratio" on the "Energy
saving operation" screen, then push the
" Set" [
Set
2
Push the "
+
%
" %-" [
–
%
The Energy saving ratio can be set within the range
from 50% to 100% by 1%. The lower the value is
set, the higher the power saving effect becomes.
3
Push the [ MENU] button.
" Setting" appears on the screen, then the screen
returns to the "Energy saving operation" screen.
‒ 31 ‒
Installation Manual
] button to select
4
F1] button to select "ON",
MENU] button.
→" [ F2] button to select
MENU] button.
] button to select
4
F2] button.
%+" [ F1] /
F2] button to set the value.