Removal And Replacement Procedures; Extending The Disk Drive Drawer - HP HPE D6020 Maintenance And Service Manual

Removal and replacement procedures

Required tools
The following items are required for some procedures:
• T-8 Torx screwdriver
• T-10 Torx screwdriver
• T-15 Torx screwdriver
• Philips screwdriver

Extending the disk drive drawer

CAUTION: To prevent improper cooling and thermal damage, do not operate the D6020 for more than 10 minutes
with the drawer open. If the drawer is extended for more than 10 minutes while the system is powered on, the
system could shut down unexpectantly. This shutdown can occur even though internal fans maximize their speed
to cool down the system.
Prerequisites
• Verify that all I/O bays contain either an I/O module or an I/O blank. If I/O bays are empty, then the disk drive drawer
does not open.
• Verify that the I/O modules or I/O blanks are fully seated and their handles are in the locked position. If I/O modules or
I/O blanks are not fully seated with their handles in the locked position, then the disk drive drawer does not open.
Procedure
1. Extend the disk drive drawer.
WARNING: To reduce the risk of personal injury or damage to the equipment:
• Do not extend the disk drive drawers beyond the supporting surface when the unit is not installed in a rack.
• Ensure that only one disk drive drawer is extended at a time.
10
Removal and replacement procedures