HP Compaq dx2250 Service & Reference Manual page 81

Removing a 3.5" Hard Drive
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power, and data cables from the back the drive.
5. Remove the four retaining screws that secure the drive in the drive cage (1).
6. Slide the drive out of the rear of the drive bay (2).
To replace the hard drive cage, reverse the removal procedure. No guide screws are required for drives
installed in the hard drive bays (bays 4 and 5).
NOTE:
operating system, software drivers, and/or any software applications that were preinstalled on
the computer. Follow the instructions in the guide included with the CD. When the restore process
has been completed, reinstall any personal files that were backed up before replacing the hard
drive.
ENWW
(Access Panel on page
(Front Bezel on page
If you replaced the primary hard drive, the Restore Plus!CD may be used to restore the
(Preparation for Disassembly on page
60)
61)
59)
Drives 75