HP Compaq dx2250 Service & Reference Manual page 43

Table 4-1 Security Features Overview
Option
Setup Password
Power-On Password
Password Options
(This selection will appear only if a
power-on password is set.)
Pre-Boot Authorization
Smart Cover
Embedded Security
Device Security
Network Service Boot
ENWW
Description
Allows you to set and enable setup (administrator) password.
NOTE: If the setup password is set, it is required to change
Computer Setup options, flash the ROM, and make changes to
certain plug and play settings under Windows.
See the Computer Setup (F10) Utility Guide on the Documentation and
Diagnostics CD for more information.
Allows you to set and enable power-on password.
See the Computer Setup (F10) Utility Guide on the Documentation and
Diagnostics CD for more information.
Allows you to specify whether the password is required for warm boot
+Alt+Del).
See the Computer Setup (F10) Utility Guide on the Documentation and
Diagnostics CD for more information.
Allows you to enable/disable the Smart Card to be used in place of the Power-
On Password.
Allows you to:
● Enable/disable the Cover Lock.
●
Enable/disable the Cover Removal Sensor.
NOTE: Notify User alerts the user that the sensor has detected that
the cover has been removed. Setup Password requires that the
setup password be entered to boot the computer if the sensor detects
that the cover has been removed.
This feature is supported on some models only. See the Computer Setup
(F10) Utility Guide on the Documentation and Diagnostics CD for more
information.
Allows you to:
●
Enable/disable the Embedded Security device.
● Reset the device to Factory Settings.
This feature is supported on some models only. See the HP ProtectTools
Security Manager Guide at www.hp.com
Enables/disables serial ports, parallel port, front USB ports, system audio,
network controllers (some models), and SCSI controllers (some models).
Enables/disables the computer's ability to boot from an operating system
installed on a network server. (Feature available on NIC models only; the
network controller must reside on the PCI bus or be embedded on the system
board.)
(Ctrl
Asset Tracking and Security 37