HP Compaq dc7700 DT Hardware Reference Manual page 25

8. Open both latches of the memory module socket (1), and insert the memory module into the socket
(2).
Figure 2-11
NOTE
with the tab on the memory socket.
A DIMM must occupy the XMM1 socket.
For maximum performance, populate the sockets so that the memory capacity of Channel
A is equal to the total memory capacity of Channel B. Refer to Populating DIMM Sockets
for more information.
9. Push the module down into the socket, ensuring that the module is fully inserted and properly
seated. Make sure the latches are in the closed position (3).
10. Repeat steps 8 and 9 to install any additional modules.
11. Replace the access panel.
12. If the computer was on a stand, replace the stand.
13. Reconnect the power cord and turn on the computer.
14. Lock any security devices that were disengaged when the computer cover or access panel was
removed.
The computer automatically recognizes the additional memory when you turn on the computer.
ENWW
Installing a DIMM
A memory module can be installed in only one way. Match the notch on the module
Installing Additional Memory 19