HP Compaq d330 DT Hardware Reference Manual page 39

✎
Hardware Reference Guide
9. Connect the opposite end of the data cable to the appropriate
system board connector.
If your system has only one SATA hard drive, you must connect the
hard drive to the connector labeled SATA 0 first to avoid any hard
drive performance problems.
Hard Drive Connector Locations
SATA hard drive connector
1
PATA hard drive connector
2
10. Lift the hard drive bracket up and into position on the front of the
chassis.
11. Replace the front bezel and computer cover.
12. If you normally lock the Smart Cover Lock, use Computer Setup
to relock the lock and enable the Smart Cover Sensor.
13. Reconfigure the computer, if necessary. Refer to the Computer
Setup (F10) Utility Guide on the Documentation Library CD for
instructions about using Computer Setup.
www.hp.com
Hardware Upgrades
2–29