HP ProCurve 4000M Installation Manual page 29

2.
.
partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack
3.
lower the switch with
mounting brackets onto the
partially installed screw
Partially install a screw (5/8-inch number 12-24) into the top hole of a pair
of holes that are 0.5 inches apart in each rack/cabinet upright as shown
in the illustration below. Ensure that the screws are at the same level in
each upright.
Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.
Installing the Switch 4000M and 8000M
Installation Procedures
2-11