Part Numbers And Field Replaceable Units - HP ProCurve 3500-24 Reference Manual

76
Table A5: LED status indicators for HP ProCurve Switch 3500 and 6200yl series (continued)
LED State
Mdl—Module On (green)
Status *
Off
Blinking (orange)
Port LEDs (Link and Link (green)
Mode)
Mode (green)
LED Mode Select Act (green)
FDx (green)
PoE (green)
Spd (green)
Usr (green)
* The HP ProCurve Switch 3500-24, 3500-48, 3500-24-PoE, and 3500-48-PoE do not support the 10-GbE module .
** The HP ProCurve Switch 3500-24 (J9470A) and 3500-48 (J9472A) do not support PoE .

Part numbers and Field Replaceable Units

Appendix L lists various part numbers and Field Replaceable Units (FRUs) for the HP ProCurve Switch 8200zl,
5400zl, 3500, and 6200yl series .
Indication
Expansion module is plugged in to expansion slot and operating correctly .
Expansion module is not plugged in to expansion slot .
Expansion module is plugged in to expansion slot but has experienced a fault .
Indicates the Port LEDs are displaying link information:
• If the Port LED is on, the port is enabled and receiving a link indication from the connected device.
• If the Port LED is off, the port has no active network cable connected, or is not receiving link beat
or sufficient light . Otherwise, the port may have been disabled through the switch console, the Web
browser interface, or HP ProCurve Manager .
If the Port LED is blinking (orange) simultaneously with the Fault LED, the corresponding port has failed
its self-test .
The operation of the Mode LED is controlled by the LED Mode select button, and the current setting
is indicated by the LED Mode indicator LEDs near the button . Press the button to step from one view
mode to the next . The default view is Activity (Act) .
Flickers to show relative activity .
Flickers to show relative activity .
Indicates which ports are supplying power:
• If the Mode LED is on, the port is providing PoE power.
• If the Mode LED is off, the port is not providing PoE power.
• If the Link LED is on, the port is enabled for PoE.
• If the Link LED is off, the port is disabled for PoE.
• If the Link LED is blinking, the port has an error or the port is denied power due to insufficient power.
Indicates speed of operation of each port:
• If the Port LED is off, the port is operating at 10 Mbps.
• If the Port LED is blinking, the port is operating at 100 Mbps.
• If the Port LED is on continuously, the port is operating at 1000 Mbps.
Reserved for future development .