Table of Contents
Advertisement
• Before freezing packages of fresh foods, make sure they are
cooled to ambient temperature.
• Ice and frost layer increase energy consumption, so do
clean the appliance as soon as the layer is 3-5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is
poor, the energy consumption is substantially higher. To
restore efficiency, replace the gasket.
Important
• If you've bought this appliance to replace an old one
equipped with a lock that cannot be opened from inside
(lock, bolt), make sure that the lock is broken. This will make
it impossible for the children to lock themselves in
the appliance and suffocate.
• Mind to connect the appliance correctly to the mains supply
(see Connection to the Mains Supply).
• Do not touch the cooled surfaces while the appliance
operates, especially not with wet hands, because the skin
might stick to the cold surfaces.
• Do not freeze bottled drinks, especially not fizzy ones such
as mineral water, sparkling wine, beer, cola etc., because
liquid expands during freezing and the glass bottle is very
likely to blow up.
• Never try to eat frozen food (bread, fruit, vegetables),
because you may get frostbites.
• Carefully check the foods for color and smell and if you are
in doubt about their quality, throw them away because they
may be spoiled and therefore dangerous to eat.
• Disconnect the appliance from the mains before repairing
(only a qualified technician should repair it) and before
cleaning.
• Use only enclosed tools or tools recommended by the
manufacturer.
• For the sake of environment protection - be careful not to
damage the rear wall of the appliance (the condenser unit or
the tubes - for example when moving the appliance) or any
part of the refrigerating system inside the appliance.
• The refrigerating system of the appliance is filled with
refrigerant and oil, so when the appliance is damaged,
handle it with care and dispose it of in compliance with
environmental protecting precautions. (See We Care for the
Environment).
• Heating element incorporated in the appliance, all around
the rim, is controlled by the operation of the compressor and
it prevents the door gasket to freeze on to the freezer
housing.
• If the supply cord is damaged, it must be replaced by the
manufacturer or his service agent or a qualified person in
order to avoid hazard.
Placing and Installation
Choosing the Right Place
Place the appliance in dry and well ventilated room. Allowed
ambient temperature depends on the model (class) of the
appliance and is stated on the rating plate of the appliance.
Never place the appliance near heat emitting devices (e.g.
cooker, radiator, water heater and similar devices) and do not
expose it to direct sunlight.
The appliance should be positioned at least 3 cm away from
the electric or gas cooker and at least 30 cm away from the oil
or coal stove. If this is not possible, use an appropriate
insulation.
Class
SN (sub-normal)
N (normal)
10
Ambient temperature
from + 10°C to + 32°C
from + 16°C to + 32°C
• Condenser at the bottom of the appliance must always be
clean and dust free (see Section Cleaning of the
Appliance).
• Always consider instructions stated in sections Positioning
and Energy Saving Tips, otherwise the energy consumption
is substantially higher.
• The rating plate is in the interior or on the rear wall of the
appliance.
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the recycling
of electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment and
human health, which could otherwise be caused by
inappropriate waste handling of thisproduct. For more
detailed information about recycling of this product,
please contact your local city office, your household waste
disposal service or the shop where you purchased the
product.
Storing Time During Power Supply Interruption
Avoid opening the freezer in case of failure or power supply
interruption! In case the interruption is extended over longer
period of time (15 hours).
Disposing of the Worn Out Appliance
• When your appliance finally wears out, dispose it of. If the
appliance has a lock, break it, in order to prevent eventual
accidents (danger of children get locked inside the
appliance).
• The refrigerating system of the appliance is filled with
refrigerant and insulating substances which should be
separately treated and processed. Call your nearest
authorised service agent or specialised servicing centre. If
you don't find one, contact your local authorities or your
distributor. Be careful not to damage the tubes on the rear
wall of the appliance (danger of pollution).
• To avoid pollution of the environment make sure not to
damage the hose at the bottom of the appliance.
Connection to Power Supply
Connect the appliance with the cable and plug to the power
supply socket outlet with a ground terminal (safety socket).
Required nominal voltage and frequency are indicated on the
rating plate.
The connection to the mains supply and earthing have to be
made according to current standards and regulations. The
appliance resists temporary voltage tolerance up to -6 to +6 %.
Adjusting the height of the appliance
The appliance is equipped with four adjustable legs, so that the
height may be adjusted from 82 to 90 cm. The height must be
adjusted prior building the appliance into the opening slot, and
it should be set at such height that the top panel of the
appliance fits exactly below the kitchen worktop (see Mounting
Instructions).
Instructions for Use
Advertisement
Table of Contents
