How To Use Your Vacuum Cleaner - Eureka NEN110B Owner's Manual

How to use your vacuum cleaner

CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments
or removing and emptying the dust cup.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-off. If for any reason the vacuum eaner cl
does overheat, the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the
vacuum cleaner off and unplug it from the electrical socket. Remove and empty the dust cup and check the
vacuum deaner for blockages. Allow the vacuum cleaner to cool for approximately 1 hour (if you have
cleaned the incorrect space, please wait 24 hours for the filters to fully dry before putting them back into the
machine).
Operation
Pull the power cord out of the vacuum cleaner and stop when you see
the yellow mark. Make sure the red mark is not visible or you have
pulled too far. When done cleaning, turn off the power, pull the plug
out of the electrical socket, and then push the rewind button until the
cord is completely retracted.
To turn on the vacuum cleaner, push the plug into an electrical socket
and press the power button.
Switching between carpet & hard floor
There is a switch located on the floor nozzle that can be pressed with
your foot to switch between floor modes. The symbols shown below
correspond to the type of floor the setting is for.
Position 1: Bristles extended for hard floor
Position 2: Bristles retracted for carpet
6
Eureka Customer Service HELPLINE 1-800-282-2886