Fig. 15: Connecting The Compressor Cooling Air Intake; Fig. 16: Attaching The Support - ABB HT575750 Operation Manual

Operation Manual / 4 Product description / A130-M.. - A145-M..
2 Removing and Installing / 2.3 Installing the turbocharger
2.3.6 Connecting the turbocharger
Connect cable to speed sensor (86515).
u
Connect all gas, water and air lines according to the instructions of the enginebuilder.
u
Version with water-cooled bearing casing
Fit the water pipes according to the instructions of the enginebuilder.
u
Version with compressor wheel cooling
CAUTION
Failure of compressor wheel cooling
Any prolonged failure of the compressor wheel cooling will shorten the re-
placement interval of the compressor wheel.
Make sure there is an uninterrupted supply of cooling air during opera-
u
tion.
Fig. 15: Connecting the compressor cooling air intake
Remove the screw plug on the connection for the compressor wheel cooling (06) and fit
u
the cooling air line.
2.3.7 Attaching the support
Fig. 16: Attaching the support
If present: Attach support (61301) to engine support or to a connecting piece.
u
© Copyright 2017 ABB. All rights reserved. HZTL4031_EN Revision F August 2017