Table of Contents
Advertisement
DISPLAY
DISPLAY
TV Aspect
Display Mode
Progressive Scan
TV Output Select
DVD-V
DVD-A
TV Aspect
4:3: Select when a standard 4:3 TV is connected.
16:9: Select when a 16:9 wide TV is connected.
DVD-V
DVD-A
Display Mode
Display Mode setting works only when the TV Aspect
mode is set to "4:3".
Letterbox: Displays a wide picture with bands on the
upper and lower portions of the screen.
Panscan: Automatically displays the wide picture on the
entire screen and cuts off the portions that do not fit.
DVD-V
Progressive Scan
Progressive Scan Video provides the highest quality
pictures with less flickering.
If you are using the Component Video jacks for
connection to a TV or monitor that is compatible with a
progressive scan signal, set Progressive Scan to On.
To Turn ON progressive scan:
Connect component out of the DVD to the input of
your monitor/television, set your television or monitor
to Component Input.
1. Select "Progressive Scan" on the DISPLAY menu
then press B.
2. Select "On" using the v / V buttons.
3. Press ENTER to confirm your selection.
The confirm menu will appear.
DISPLAY
TV Aspect
Display Mode
Progressive Scan
TV Output Select
Prev.
16 : 9
Widescreen
Off
RGB
Move
Select
DVD-A
On
Off
Move
ENTER
Notes:
At this point the only video displaying is Component
video. If your screen goes to a black screen, your
television/display may not be compatible to
progressive scan.
In this case the player will time out after 10-12
seconds if no other keys are pressed. After the unit
times out, the player will automatically return to
standard format, and your picture will return.
4. When the confirm menu appears on your screen
Cancel is highlighted as default. Use the b / B
buttons to highlight Enter.
5. Pressing ENTER will set the player to Progressive
scan mode.
Caution:
Once the setting for progressive scan output is
entered, an image will only be visible on a progressive
scan compatible TV or monitor. If you set Progressive
Scan to On in error, you must reset the unit. First,
remove the disc in the DVD Player. Next, press STOP
( x ) again and hold it for five seconds before
releasing it. The video output will be restored to the
standard setting, and a picture will once again be
visible on a conventional analog TV or monitor.
TV Output Select
Set the player's TV Output Select options according to
the TV connection type.
YPbPr: When your TV is connected with the
COMPONENT VIDEO OUT/PROGRESSIVE SCAN
jacks on the DVD player.
RGB: When your TV is connected with the SCART
(RGB signal) jack.
AUDIO
Each DVD disc has a variety of audio output options.
Set the player's AUDIO options according to the type
of audio system you use.
AUDIO
Dolby Digital
DTS
MPEG
Sample Freq.
5.1 Speaker Setup
DRC
Bitstream
Bitstream
PCM
48 kHz
Select
On
Move
Select
13
Advertisement
Table of Contents
