Table of Contents
Advertisement
High temperature
Activate this option for improved dishwashing results. The ma-
chine then uses a higher temperature for the main wash. This
option cannot be activated if the Time saver option is selected.
If you want to use the lower temperature, press until the field next
to the button turns off.
You can vary the temperature as shown below:
Heavy wash:
Normal program:
Daily wash:
Eco wash:
Long dry
The higher temperature in the final rinse and longer drying im-
proves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can
be used with all programs except Time program. This option
cannot be activated if the Time saver option is selected.
If you want a program with Short dry, press so that the field next
to the button turns off.
Time saver
This option shortens the program time, but uses more energy
and water. This option can be selected with Daily wash, Heavy
wash or Normal program.
Delayed start
When you select Delayed start, the dishwasher will start 1–24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at
a time and starts after the selected delay.
Press and hold Start/Stop for five seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the program.
Start the dishwasher
Press and hold Start/Stop until the display flashes three times
with the remaining time. This indicates that the program has
started. Close the door properly, otherwise the dishwasher will
not start. The display indicates
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.
8
60 °C / 70 °C
48 °C / 65 °C
60 °C / 65 °C
53 °C / 60 °C
if the door is open.
Time remaining
Once you have selected a program and options, the display indi-
cates how long the program took the last time it was used. Once
you have started the dishwasher, the display indicates how much
program time remains. The remaining time is updated after the
water for the final rinse has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the ambi-
ent temperature and other factors.
While the program is running, the time counts down and the re-
maining program time is shown on the display. The remaining
time is shown, for example, as 1:15, which means the program
will run for another 1 hour and 15 minutes.
NOTE!
During the first run of each program, the remaining time dis-
played can be slightly misleading, as the dishwasher is estimat-
ing the time. When you run the program a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the program.
Stopping or changing a program
In order not to accidently press a button and cancel the current
program, you must press and hold Start/Stop for five seconds if
you want to change programs after starting the dishwasher. Add
more detergent if the lid of the detergent dispenser has opened.
Then choose a new program and press Start/Stop.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the program.
If the dishwasher is turned off using
the main power switch or due to a
power failure
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
Once the program has finished
Once the program has finished, "End" appears on the display.
At the end of the program, you will hear a short beep. Chapter
Settings describes how to change this function.
Once the dishwasher has finished, it only uses standby power.
Turn off the dishwasher with the main power switch if you want
to cut the power completely. Shut off the water tap after every
use.
Drying
For additional drying the door should be opened 35 mm upon
completion of the drying cycle. For more information, see page
16 in the chapter Technical information.
Advertisement
Table of Contents
