Asko D5456SS Operating Instructions Manual page 14

Problem
Rattling sound when dishwashing.
The dishwasher does not start.
1 minute appears in the display.
Water remains in the dishwasher.
Bad odour in dishwasher.
The dishes are not dry enough.
Cannot close door.
14
Possible causes
The dishes are not correctly placed or the
spray arms are not rotating.
The Start/Stop start button has not been
pressed for long enough.
The door is not properly closed.
A fuse/circuit breaker has been tripped.
The plug is not plugged into the wall socket.
The water tap is turned off.
Overflow/leaks
A whirring sound (the drainage pump) is
heard from the dishwasher and does not stop
when the main power switch is turned off.
Check that the Delayed start option has not
been selected.
The program is taking longer than estimated.
Blocked drainage hose.
Kink in drainage hose.
The filters are blocked.
The filter is not locked in completely.
Debris in the drainage pump.
Dirt around the seals and in corners.
Low temperature programs have been select-
ed for a prolonged period.
Drying power too low.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage is set
too low.
The baskets are not correctly positioned.
Action
Check that the dishes are placed securely.
Spin the spray arms to make sure they can
rotate.
Press and hold Start/Stop until the display
flashes three times with the remaining time.
Check.
Check.
Check.
Check.
Check.
Turn off the water tap. Pull out the plug and
call the service division.
Press and hold Start/Stop for five seconds if
you want to cancel the Delayed start option.
None, next time the program is run the cor-
rected time will be displayed.
Loosen the drainage hose where it connects
to the sink unit's water trap. Check that no
debris has fastened. Is the cone-shaped part
of the pipe cut to an inner diameter of at least
14 mm?
Check that the hose is free from kinks and
sharp bends.
Clean the coarse and fine filters.
Ensure filter is completely locked with handle
pointing towards the door.
Clean the drainage pump. See the section
Care and cleaning.
Clean with washing-up brush and low foam-
ing cleaner.
Run a program with a higher temperature
about once a month.
Activate the Long dry option.
Fully load the dishwasher.
Top up with rinse aid or increase the rinse
aid dosage. See the sections Before washing
for the first time and Settings.
Open the door a little once the program has
finished.
Check that the baskets are correctly posi-
tioned horizontally.
Check that the dishes are not blocking the
baskets from sliding properly into place.