Table of Contents
Advertisement
Installation Instructions - Flush Installation
STEP 5 INSTALL ANTI-TIP BRACKET (cont.)
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out to
remove.
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out to
remove.
STEP 6 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
• To level the back of the unit, turn the 7/16" hex nut
located above the front wheels. Turn clockwise to raise
or counterclockwise to lower the unit.
• For front leveling, use a 1-1/4" open-end wrench.
• Adjust height of unit to match installation cutout opening
84-1/2". The unit should be level and plumb with
cabinetry.
NOTE: Raise
appliance
until the case
top comes in
contact with
the 1" spacer
block mounted
to the underside
of the cabinet
soffit. Appliance
should be level at fully raised position.
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so
now.
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the
back of the unit.
• The unit has "L" bolts in the upper left and right
corners inside of the access compartment. These bolts
will interlock with the wall bracket and secure the unit
using the washers and hair pin cotters in the hardware
kit once the unit has been leveled and is in the final
position.
CAUTION
The rear leveling wheels and front leveling legs are
limited to a maximum height adjustment of 1". If the
installation requires more than 84-1/2" height, the installer
should elevate the unit on a sheet of plywood or runners.
Cabinetry trim could also be added across the top of the
opening to shorten the opening. If you attempt to raise
the unit more than 1", you will damage the front leveling
legs and the rear leveling wheels.
ATTENTION
Les roues de nivellement arrière et les pattes de
nivellement avant permettent un réglage maximal de 25
mm (1 po). Si l'ouverture pour l'appareil ménager a une
hauteur supérieure à 2,15 m (84-1/2 po), l'installateur doit
élever l'appareil ménager sur une feuille de contre-plaqué
ou des glissières. Il est également possible d'ajouter
des baguettes de finition des placards sur le haut de
l'ouverture afin de la réduire. Lever l'appareil ménager
de plus de 25 mm (1 po) endommage les pattes de
nivellement avant et les roues de nivellement arrière.
35
Advertisement
Table of Contents
