Repeater Mode Configuration - Hawking HWBA54G User Manual

Channel
Security
Advance setting
Access Filter
Click Apply button at the bottom of the screen to save the above configurations. You can now configure
other advance sections or start using the Access Point.

Repeater Mode Configuration

If you want an access point to bridge wired Ethernet network and provide
connection service for other wireless station at the same time, you have to set the
access point to "Repeater mode". Simply speaking, "Repeater mode" function is
the combination of "AP mode" and "PMP mode".
Select the appropriate channel from the list provided to correspond with
your network settings. Channels differ from country to country. Channel
1-11 are available in North America.
Disable: Disable the security function.
WEP: WEP is an authentication algorithm, which protects authorized
Wireless LAN users against eavesdropping. The Authentication type and
WEP key of wireless stations must be the same with the Access Point.
This Access Point supports 64/128 -bit WEP Encryption function. With this
function, your data will be transmitted over the wireless network securely.
# You can refer to the detail setting from chapter 3.2.6.
WPA: You can use a pre-shared key to authenticate wireless stations
and encrypt data during communication. When you enabled WPA mode,
you can not use WEP encryption.
# You can refer to the detail setting from chapter 3.2.7.
It provides more powerful features for you to configuring.
# You can refer to the detail setting from chapter 3.2.8.
This Access Point allows you to provide a Filter List of MAC addresses
that are allowed associating with this AP.
# You can refer to the detail setting from chapter 3.2.9.