Replacing Filter - Makita XOB03 Instruction Manual

Cordless finishing sander

Hide thumbs

Table Of Contents

Table of Contents

Available languages

CAUTION:

The O ring may come out of the

sanding base while replacing the pad. Set the O

ring back in the circular grooves around the cen-

ter of the base before installing the optional pad.

Fig.13

► 1. O ring 2. Sanding base 3. Circular grooves

Installing and removing dust bag

Attach the dust bag over the tapered dust spout at the

back end of the motor housing. Put the dust inlet of the

bag onto the dust spout as far as it will go to avoid it

from coming off during operation.

Fig.14

► 1. Dust spout 2. Dust inlet 3. Dust bag

NOTE: Make sure to attach the dust bag with its

zipper slider facing downwards.

NOTE: To ensure optimal dust collecting, empty the

dust bag when it becomes filled to approximately half

of its capacity.

Remove the dust bag from the tool and pull the fas-

tener out. Then gently shake or tap the dust bag to

empty.

Installing and removing dust box

Optional accessory

Attach the dust box over the tapered dust spout at the

back end of the motor housing. Put the dust nozzle onto

the dust spout as far as it will go to avoid it from coming

off during operation.

Fig.15

► 1. Dust spout 2. Dust nozzle 3. Dust box

NOTE: To ensure optimal dust collecting, empty the

dust box when it becomes filled to approximately half

of its capacity.

Remove the dust box from the tool.

Detach the dust nozzle from the box while

pressing and holding the locking latches on both

sides of the box.

Gently shake or tap the dust box to empty.