Wireless Remote Controller - LG HS-24IV Owner's Manual

Wireless Remote Controller

The controls will look like the following.
PLASMA
5
13
4
2
7
ON OFF
11
8
6
STEP
15
Operation Mode
Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Air Circulation
NOTE
To use the functions printed in blue at the bottom of
the buttons press 2 nd F button first and then the
required function button. Pressing the 2
activates the blue printed function of the respective
button. To cancel the function press the 2nd F button
again else it will automatically cancel if remains idle
after 10 seconds.
Signal transmitter
1
3
10
CANCEL
9
SET
12
AUTO CLEAN
17
18
14
16
Flip-up door
(opened)
nd F button
1. START/STOP BUTTON
Used to turn off/on the unit.
2. OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR BUTTON
Used to select fan speed in four steps
low, medium, high and CHAOS.
5. JET COOL BUTTON
Used to start or stop the speed cooling.
(It operates fan in super high speed in cooling mode)
6. AUTO SWING BUTTON
Used to stop or start louver movement and set the
desired up/down airflow direction.
7. ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation.
8. TIME SETTING BUTTONS
Used to adjust the time.
9. TIMER SET/CANCEL BUTTON
Used to set and to cancel the timer operation.
10. SLEEP MODE AUTO BUTTON
Used to set sleep mode auto operation.
11. ENERGY-SAVING COOLING MODE BUTTON
Used to circulate the room air without cooling or heating.
12. ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
13. PLASMA BUTTON(OPTIONAL)
Used to start or stop the plasma-purification function.
Only air circulation in the room.
1) Turn off indoor with remote control.
2) Press plasma button. Then fan will start.
3) Remote fan speed with fan button.
4) To go back to "heating" of "cooling" mode, Press
plasma button and select "heating" of cooling" with
operation mode selection.
14. VERTICAL AIRFLOW DIRECTION CONTROL
BUTTON (OPTIONAL)
Used to set the desired vertical airflow direction.
15. RESET BUTTON
Used prior to resetting time.
16. 2nd F BUTTON
Used prior to using modes printed in blue at the
bottom of buttons.
17. AUTO CLEAN BUTTON(OPTIONAL)
Used to set auto clean mode.
In some models this button has a 2nd function of LED
luminosity control.
18. LCD LUMINOSITY BUTTON(OPTIONAL)
Used to adjust LCD luminosity.
Operating Instructions
Owner's Manual 9