Table of Contents
Advertisement
STEP AND
ITEMS T
O
CHECK[
01)
Turn on the power switch while
FUNCTION OF
simultaneously pressing the
LCD, BUZZER
needle up/down button and thread
AND LAMP
cutter button.
Press the needle up/down button
within the 1.5 seconds to enter the
self-diagnostic mode.
Press the "1" key.
If the result is correct condition, press
the start/stop button to proceed the
next step.
If the result is defective condition,
press the reverse stitch button to
proceed the next step.
02)
BUTTON
Press the buttons 1 to 4.
If the result is correct condition, press
the start/stop button to
proceed the next step.
If the result is defective condition,
press the reverse stitch button to
proceed the next step.
03)
Lower the buttonhole lever.
BUTTONHOLE
Move the buttonhole lever back and
SENSOR
forth.
If the result is correct condition, press
the start/stop button to proceed the
next step.
If the result is defective condition,
press the reverse stitch button to
proceed the next step.
04)
Move the bobbin winder spindle to
BOBBIN
the right.
WINDER
Return it to the left.
SWITCH
If the result is correct condition, press
the start/stop button to
proceed the next step.
If the result is defective condition,
press the reverse stitch button to
proceed the next step.
SELF-DIAGNOSTIC TEST
PROCEDURE
1
2
3
4
CORRECT CONDITION
Sewing lamp and LCD backlight lit.
LCD displays "----".
Buzzer sounds. LCD displays symbols
and numbers and blinks.
LCD displays "02".
Buzzer sounds when button is
pressed. Button number is displayed
when the button is pressed.
LCD DISPLAYS "S1" WHEN BUTTON 1 IS PRESSED.
LCD DISPLAYS "S2" WHEN BUTTON 2 IS PRESSED.
LCD DISPLAYS "S3" WHEN BUTTON 3 IS PRESSED.
LCD DISPLAYS "F3" WHEN BUTTON 4 IS PRESSED.
LCD displays "03".
When the buttonhole lever is pulled,
buzzer sounds and LCD displays BH
symbol.
When the buttonhole lever is pushed,
buzzer sounds and LCD displays BH
symbol.
LCD displays "04".
When the bobbin winder spindle is
moved to the right, buzzer sounds and
LCD displays the bobbin symbol.
When the bobbin winder spindle is
moved to the left, buzzer sounds and
LCD displays "04".
Bobbin symbol
26
DEFECTIVE CONDITION
Sewing lamp does not lit.
LCD backlight does not lit.
LCD does not display.
Buzzer does not sound.
LCD does not turned on.
LCD does not display any
symbols or not in order.
–REMEDY–
Replace the printed circuit
board A.
Replace the machine lamp.
Replace the touch panel.
Replace the printed circuit
board F.
Buzzer does not sound.
LCD does not display the
number correctly.
–REMEDY–
Replace the printed circuit
board A.
Replace the printed circuit
board F2.
Buzzer does not sound.
BH symbol does not appear.
–REMEDY–
Adjust the BH lever sensor
BH symbol
position.
Replace the BH lever sensor.
Replace the printed circuit
board A.
Buzzer does not sound.
Bobbin symbol is not
displayed.
–REMEDY–
Adjust the bobbin winder
switch position.
Replace the bobbin winder
switch.
Replace the printed circuit
board A.
Advertisement
Table of Contents
