Table of Contents
Advertisement
This controller allows the Movie Camera to be used more
conveniently by a left-handed user.
(86)
(87)
(88)
(86)
Recording Start/Stop Button [REC]
(87)
Zoom Lever [W/T]
(88)
Photoshot Button [PHOTO SHOT]
≥Insert the plug securely into the [REMOTE] Socket as
far as it will goes. A loose connection will spoil normal
operation.
The Remote Controller
ª Inserting a Button-type Battery
Before using the Remote Controller, insert the supplied
button-type battery.
1
While pressing the Stopper 1, pull out the Battery
Holder.
1
2
Insert the button-type battery with the (i) marking
facing upward.
3
Insert the Battery Holder into the Remote Controller.
≥When the button-type battery is exhausted, replace it with a
new CR2025 battery. (A battery is normally expected to last
about 1 year. However, it depends on operation
frequency.)
Before Use
≥Make sure to match the poles correctly when inserting the
battery.
WARNING
"THE LITHIUM BATTERY IS A CRITICAL
COMPONENT (TYPE NUMBER CR2025
MANUFACTURED BY PANASONIC).
IT MUST NEVER BE SUBJECTED TO
EXCESSIVE HEAT OR DISCHARGE. IT
MUST THEREFORE ONLY BE FITTED IN
EQUIPMENT DESIGNED SPECIFICALLY
FOR ITS USE.
REPLACEMENT BATTERIES MUST BE OF
THE SAME TYPE AND MANUFACTURER.
THEY MUST BE FITTED IN THE SAME
MANNER AND LOCATION AS THE
ORIGINAL BATTERY, WITH THE
CORRECT POLARITY CONNECTIONS
OBSERVED.
DO NOT ATTEMPT TO RE-CHARGE THE
OLD BATTERY OR RE-USE IT FOR ANY
OTHER PURPOSE. IT SHOULD BE
DISPOSED OF IN WASTE PRODUCTS
DESTINED FOR BURIAL RATHER THAN
INCINERATION."
ª Using the Remote Controller
1
Direct the Remote Controller to the Remote Control
Sensor
(48)
of the Movie Camera and press an
appropriate button.
≥Distance from the Movie Camera: Within approximately
5 metres
≥Angle: Within approximately 5o in the upward, and 15o in
the downward and horizontal directions from the central
axis
≥The above operative ranges are for indoor use. Outdoors
or under strong light, the Movie Camera may not operate
properly even within the above ranges.
≥Within a 1-metre range, you can also use the Remote
Controller on the LCD Monitor side of the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used simultaneously, they can
be operated individually by selecting different Remote
Controller Modes.
≥If the Remote Controller Mode of the Movie Camera and
that of the Remote Controller do not match, [REMOTE]
Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to
the desired Remote Controller Mode. (
Setup on the Remote Controller:
2
[VCR1]:
Press the [D] Button and [∫] Button simultaneously. 1
[VCR2]:
Press the [E] Button and [∫] Button simultaneously. 2
-7-
5˚
15˚
(48)
15˚
15˚
)
-12-
T
W
6
1
5
STILL ADV
PAUSE STILL ADV
1
E
;
D
INDEX
STOP
INDEX
K
L
∫
SELECT
Advertisement
Table of Contents
