Operating The Dishwasher - Bosch SHE9ER55UC Operating Instructions Manual

Operating the Dishwasher

NOTE: The SHE9ER55UC models have hidden controls, therefore, the door must be opened before chang-
ing settings and closed after changing settings.
Start the dishwasher
Press the [On/Off] button. The LED of the last selected cycle flashes.
1
Select a cycle and desired options.
2
Press [Start].
3
Cancel a cycle
Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".
1
Wait about 1 minute while the dishwasher drains.
2
Open the door and press the [On/Off] button.
3
Interrupt a cycle
Press the [On/Off] button to turn the unit off.
1
To resume the cycle, press the On/Off button again.
2
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
Press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "r:05".
4
Press the "C" button to select the desired setting.
5
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
Press [Start] to save the setting.
6
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
Press the [On/Off] button.
1
Press the [+] button until the display jumps to "h:01".
2
Press the [+] or [-] button until the displayed time corresponds with your requirements.
3
h:01 = 1 hour delay
h:24 = 24 hour delay
Press [Start] to activate delay start.
4
To cancel delay start:
Press the [+] or [-] button until "h:00" is indicated on the digital display.
1
Press [Start] to save setting.
2
Cycle Completion Signal (SHE9ER55UC only)
Open the door and press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "b:02".
4
Press the "C" button to increase or decrease the tone "b:00" = OFF and "b:03" = LOUDEST
5
Press [Start] to save setting and close the door.
6
13