Table of Contents

Advertisement

Tightening torque:
Spark plug:
12 N·m (1.2 kgf·m, 8.9 lb·ft)
TIP
If a torque wrench is not available when installing
the spark plug, a good estimate of the correct
torque is 1/4–1/2 turn past finger tight. However,
the spark plug should be tightened to the speci-
fied torque as soon as possible.
3. Install the spark plug cap.
EBU37000

Engine oil

8
The engine oil level should be checked before
each ride. In addition, the oil must be changed at
the intervals specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Check the engine oil level on a cold engine.
TIP
If the engine was started before checking the oil
level, warm up the engine and then wait at least
ten minutes until the oil settles for an accurate
reading.
3. Remove the engine oil filler cap, and then
wipe the engine oil dipstick off with a clean
rag.
1
1. Engine oil filler cap
4. Insert the dipstick into the filler hole, screw it
in, and then remove it again to check the oil
level.
8-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yfm 90

Table of Contents